New design “QUICKCut” taper and deburring countersinkers

The newly designed "QUICKCut" taper and deburring countersinkers enable higher service lives and cutting speeds. The completely new designed cutting geometry reduces the formation of built-up edges whilst increasing the service life at the same time by up to 25%. The new machining geometry causes a very good chip formation and thus enable the cutting speed to be increased by up to 30%.
The shaft with 3 tensioning areas allows the high cutting forces to be transferred and effectively prevents it from slipping in the chuck. These properties make the countersinker particularly good for automatic and fast feeds.
The "QUICKCut" taper and deburring countersinker also comes with a TiAIN (titanium aluminium nitride) wear-resistant coating.
The wear-resistant coating increases the surface hardness of the "QUICKCut" taper and deburring countersinker to around 3,000 HV.
Its heat resistance also increases to around 900°. The best conditions for being able to do dry countersinkings (without coolants and lubricants).
With an increased service life of almost 40%, the wear-resistant coating makes full use of its benefits.

» "QUICKCut" long-term test

Countersinkers angle: 90°
Shank: 3-surface shaft
Cutting edges: 3
Standard: DIN 335
Style: C
Material: HSS / HSS-TiAlN
Cutting direction: right hand cutting

» Technical data

» "QUICKCut" HSS

» "QUICKCut" HSS-TiAlN

The “QUICKCut” taper and deburring countersinkers are available separately the following diameters: 6,3 - 8,3 - 10,4 - 12,4 - 15,0 - 16,5 - 19,0 - 20,5 - 23,0 - 25,0 - 31,0 mm.

Or as a 5 and 6-piece set in a sturdy industrial case.

» "QUICKCut" sets HSS / HSS-TiAlN